Using Rx_Tx on the I2C Line Following Sensor
am using 2 i2c line following sensor http://www.robotshop.ca/summerour-line-following-sensor-3.html , using arduino decimila, need connect 1 of sensors on analog pin 4 , 5 (i2c) use other sensor on tx_rx since sensor have both rx , tx options.
i know how use sensor on i2c i.e. while connected pin 4 , 5 don't know how go same while on rx_tx section.
if has idea of how done greatful.
kind regards,
david.
i know how use sensor on i2c i.e. while connected pin 4 , 5 don't know how go same while on rx_tx section.
if has idea of how done greatful.
kind regards,
david.
youv'e made mess of posting link , returns "bad request" can hit modify button , edit works.
as serial data used uploading , debugging might better off using newsoftwareserial communications.
as serial data used uploading , debugging might better off using newsoftwareserial communications.
Arduino Forum > Forum 2005-2010 (read only) > Software > Interfacing > Using Rx_Tx on the I2C Line Following Sensor
arduino
Comments
Post a Comment