Skip to main content

Thread: Best 802.11n Performance (2.4GHz)

-

hello,

achieve best performance can using 802.11n laptop, , looking suggestions or advice try next.

currently, have tried performance testing in ubuntu 9.04 d-link dwa-652 (pc card) , intel 4965agn (mini pci-e). selected these cards because supported in ubuntu, not want use ndiswrapper.

however, when connected linksys wrt300n 802.11n router, , observing performance results using iperf, seeing ~15mbps throughput, laptop on same network (sitting on same table actually). done on multiple channels, eliminate possibility of interference other devices (no other devices detected on channels used).

achieve best data rates in ubuntu using 802.11n, suggest try different router, or different wireless card? want use in 2.4ghz spectrum (not 5ghz), , can use either pc card or mini-pci-express card.

thanks.



Forum The Ubuntu Forum Community Ubuntu Official Flavours Support Networking & Wireless [ubuntu] Best 802.11n Performance (2.4GHz)


Ubuntu

Comments

Post a Comment

Popular posts from this blog

CAN'T INSTALL MAMBELFISH 1.5 FROM DIRECTORY - Joomla! Forum - community, help and support

-
hi, i want install mambelfish 1.5 component in joomla! 1.0.4 stable [ sundial ] site, reason following error: failed create directory "/home/virtual/site13/fst/var/www/html/components/com_mambelfish/" i new joomla! , still not familiar it. great if build multilingual sites using joomla!. just clarify... media/ writeable administrator/components/ writeable components/ writeable images/stories/ writeable how install component? use  upload package file or use  install directory ? Board index Joomla! Older Version Support Joomla! 1.0 Extensions - 1.0.x Components
Read more

error: expected initializer before 'void'

-
whenever try compile code following error : 'error: expected initializer before 'void'' code: [select] #include <afmotor.h> af_dcmotor motor1(1, motor12_64khz); // create motor #1, 64khz pwm af_dcmotor motor2(2, motor12_64khz); // motor #2 void setup() {  serial.begin(9600);           // set serial library @ 9600 bps  serial.println("motor test!"); } void loop() { go(); backup(); halt(); }   void go() {  serial.println("all motors ahead - fast");    motor1.run(forward);  motor2.run(forward);  motor1.setspeed(255);  motor2.setspeed(255);  return; } void backup() {  serial.println("all motors backward - fast");  motor1.run(backward);  motor2.run(backward);  motor1.setspeed(255);  motor2.setspeed(255);  return; } void halt() {  uint8_t i;  for (i=255; i!=0; i--) ...
Read more

CPU load monitoring using GPIO and leds - Raspberry Pi Forums

-
Image
hello ! wrote today article on blog cpu load monitoring (using gpio , leds) on raspberry's. simple (written in little shell script), think can useful (for people want learn leds stuff on r. pi) there 5 leds turning on , off regarding cpu load: - cpu < 20%: 1 led - cpu < 40%: 2 leds - cpu < 60%: 3 leds - cpu < 80%: 4 leds - cpu < 90%: 5/5 leds - cpu >= 90%: 5 leds flashing here article: written in french, can watch youtube video , download code @ bottom of article. http://www.chteuchteu.com/2012/10/26/ra ... e-au-gpio/ if find errors in code, can post comment on article. ! up code enhancements ? raspberrypi
Read more